T2600G/L3/StaticRouting/IPv4

IPv4 Static Routing

You can manually add desired static IPv4 routing entries on this page.

IPv4 Static routing entries are non-aging entries which are manually configured by the administrator, and remain unchanged even when the topology changes. IPv4 static routes are commonly used in a relative simple and stable network. Proper configuration of IPv4 static routes can greatly improve network performance.

To create a static IPv4 routing entry:

Step1:

Click Add to load the configuration page.

Step2:

Enter the destination IP address, subnet mask, next hop and distance, then click Create.

IPv4 Static Routing Config

Destination

Specify the destination IPv4 address of the packets.

Subnet Mask

Specify the subnet mask of the destination IPv4 address.

Next Hop

Specify the IPv4 gateway address to which the packet should be sent next.

Distance

Specify the administrative distance. The distance is the trust rating of a routing entry. A higher value means a lower trust rating. Among routes to the same destination, the route with the lowest distance value will be recorded in the routing table.

Metric

Displays the metric to reach the destination IP address. .

Interface Name

Displays the name of the gateway interface.