T2600G/L3/StaticRouting/IPv4: Unterschied zwischen den Versionen
K Dirkwagner verschob die Seite T2600G/L3:StaticRouting/IPv4 nach T2600G/L3/StaticRouting/IPv4, ohne dabei eine Weiterleitung anzulegen: Textersetzung - „T2600G/L3:“ durch „T2600G/L3/“ |
K Textersetzung - „T2600G/L3:Static Routing“ durch „T2600G/L3/Static Routing“ |
||
| Zeile 1: | Zeile 1: | ||
[[Kategorie:T2600G/L3 | [[Kategorie:T2600G/L3/Static Routing]] | ||
=== IPv4 Static Routing === | === IPv4 Static Routing === | ||
Aktuelle Version vom 20. März 2023, 22:50 Uhr
IPv4 Static Routing
You can manually add desired static IPv4 routing entries on this page.
IPv4 Static routing entries are non-aging entries which are manually configured by the administrator, and remain unchanged even when the topology changes. IPv4 static routes are commonly used in a relative simple and stable network. Proper configuration of IPv4 static routes can greatly improve network performance.
To create a static IPv4 routing entry:
- Step1:
- Click Add to load the configuration page.
- Step2:
- Enter the destination IP address, subnet mask, next hop and distance, then click Create.
IPv4 Static Routing Config
- Destination
- Specify the destination IPv4 address of the packets.
- Subnet Mask
- Specify the subnet mask of the destination IPv4 address.
- Next Hop
- Specify the IPv4 gateway address to which the packet should be sent next.
- Distance
- Specify the administrative distance. The distance is the trust rating of a routing entry. A higher value means a lower trust rating. Among routes to the same destination, the route with the lowest distance value will be recorded in the routing table.
- Metric
- Displays the metric to reach the destination IP address. .
- Interface Name
- Displays the name of the gateway interface.