T2600G/L3/StaticRouting/IPv6

IPv6 Static Routing

You can manually add desired static IPv6 routing entries on this page

IPv6 Static routing entries are non-aging entries which are manually configured by the administrator, and remain unchanged even when the topology changes

• IPv6 static routes are commonly used in a relative simple and stable network
• Proper configuration of IPv6 static routes can greatly improve network performance

Create a static IPv6 routing entry

1. Click Add to load the configuration page
2. Enter the destination IPv6 address, subnet mask, next hop and distance
3. Click Create

IPv6 Static Routing Config

Option	Beschreibung
Destination	Specify the destination IPv6 address of the packets
Prefix Length	Specify the subnet mask of the destination IPv6 address
Next Hop	Specify the IPv6 gateway address to which the packet should be sent next
Distance	Specify the administrative distance The distance is the trust rating of a routing entry A higher value means a lower trust rating Among routes to the same destination, the route with the lowest distance value will be recorded in the routing table
Metric	Displays the metric to reach the destination IP address
Interface Name	Displays the name of the gateway interface